reWASD with Flydigi Vader 3 pro question

[marialeger]

Dear devs, is it possible to make Vader 3 pro (dinput mode/dongle) seen by steam input as DS4 controller with working native gyroscope? Everything works except gyro. Maybe I'm doing something wrong?

I know you could make Virtual DS4 controller if Vader is in NS mode, but you lose analog triggers and 500hz dongle signal.

If my scenario not possible atm, please could you fix it? Sometimes i want to use Steam input UI with gyro, analog triggers and my 500hz dongle.

geometry dash lite

[strokel]

Hey there!

reWASD works with Flydigi controllers in exclusive mode, so you need to switch your controller to D-input mode.

To make your controller appear as a DS4, go to Output device settings and select the corresponding virtual controller.
Also, please make sure that controller support is disabled in the Steam controller settings.

Also, please note that due to the hardware specifics, Flydigi gamepads have a two-dimentional gyro. Because of that, there are some restrictions regarding the way gyroscope works on Flydigi controllers:

• remap gyroscope in Gyro mode only
• you cannot add Lean mappings
• you can't Calibrate gyro
• Swap gyro axis command is not available for these controllers