Scuf controller

[reWASDer]

Hello! Still not 100% sure that I got you right, sorry

So, there are two different tips!

0. Remove Turbo from the trigger itself and Unmap it:



Then,

1. Go to zones, check High one and set a trigger + turbo her.
2. Otherwise, check Low zone and set a turbo for this one:



In both cases, you will get turbo only for a limited travel zone, either when you slightly press, or when you do a full press.

[Robxxxx]

edit: im using a shift toggle on the psn button to swap between a standard layout and then the full auto layout.

[Robxxxx]

ok so the triggers on a scuf can be tightened so that they sit at the very bottom of travel so when u squeeze it barely moves and returns really fast i.e hair trigger, if i attempt to set turbo rewasd instally starts firing until i actually loosen the trigger to stock, so im trying to set the deadzone so that it only activates when i squeeze it and not at full or half squeeze as its already sitting somewehre belove those two points.

[reWASDer]

Yes, you are correct. However, not sure if you need those ones, because you can set Turbo for the whole trigger.
Could you please describe a bit more detailed what do you want to achieve?

[Robxxxx]

im not sure which dead zone to set it to, ive tried all three high mid low and neither seem to work, if u understand it correct low is at the top of travel and high is at the very end of travel?

[Star-Lord]

Hello,
Thank you for your questions, but I would ask you for giving me some details. Are set dead zones set in the trigger's settings not working? Was the "Affect gamepad hardware" option checked?

[Robxxxx]

so i have a scuf vantage two, and i can tighten the triggers down to the point barely touching them sets it off, but when i try to use turbo thru rewasd it acts as though im holding it the enitre time and using zones i cant seem to get it to work, anyone have experiance with this?