REWASD not recognizing G502 mouse unless GHub is loaded.

[Maxxgold]

REWASD is not recognizing my mouse unless I have G-Hub loaded, which is a bit disappointing, If you know anything about G-Hub. The mouse has on-board memory and should not need G-Hub for REWASD to locate.

And, can you please have the G502 available as a virtual mouse? It has a ton of buttons that are useless with REWASD. I shouldn’t have to load 2 virtual mice to have all the buttons, and so far, even with 2 loaded, I don’t have access to all the buttons with REWASD.

[RAM Stealer]

Hello!
Please follow this instruction and make sure to select your real mouse. You can "find" it with [Detection mode].
For Logitech mouse, you need to use the on-board memory mode and select an actual device instead of a virtual one created by G Hub software.

[Maxxgold]

Hello!
Please follow this instruction and make sure to select your real mouse. You can "find" it with [Detection mode].
For Logitech mouse, you need to use the on-board memory mode and select an actual device instead of a virtual one created by G Hub software.

Ok, thanks for the response. But, will that still allow me to use the mouse and Sony Navigation controller as a 360 controller?

[Maxxgold]

Ok, I did as you suggested, and REWASD does not find my G502 wireless mouse. I don’t understand how it’s so hard for a program to not recognize a G502 mouse correctly. In the config I have working it lists the mouse as Logitech_LGVirHid02, but it only has the generic virtual mouse buttons.

[RAM Stealer]

Yes. Each device in reWASD is configured independently and after setting up the mouse, you can add it back to the group with Sony Navigation and remap them into Xbox 360.

[RAM Stealer]

Ok, I did as you suggested, and REWASD does not find my G502 wireless mouse. I don’t understand how it’s so hard for a program to not recognize a G502 mouse correctly. In the config I have working it lists the mouse as Logitech_LGVirHid02, but it only has the generic virtual mouse buttons.

Please collect the mouse connection logs so that we can see what the problem is. Disconnect all other devices, remove G-Hub and follow the steps:

1. Unplug all physical controllers.
2. Open reWASD as Administrator.
3. Open 'Preferences > General' and click 'StartLog' button.
4. Connect only the device in question and wait few seconds.
5. Open 'Preferences > General' again and click 'StopLog' button.
6. Send us an archive to investigate logs.