I can't swap the yaw and roll axes on a Joy-Con controller.

[Santi-Tetra]

Please check if this command works for you.

The second question. Could you show us how you grouped your joy-cons?

I've a single Joy-Con controller (the right side or 'R' controller). I don't have the left controller. Could this be the cause that I can't swap the 'Yaw' and 'Roll' axes? Would both controllers be necessary for the axes to work well?

[Miron4ik42]

Please check if this command works for you.

The second question. Could you show us how you grouped your joy-cons?

[Santi-Tetra]

Hi!
I've a Joy-Con set up to use its gyroscope with the reWASD software. But the default axis is 'Yaw' and I intend to use the 'roll' axis. I've scrolled down to Preferences — General — Gamepads, checked the option "Gyro steering axis ---> Roll" but the reWASD software doesn't swap the axes with each other, it stays on the default 'Yaw' axis. I've two computers (PC and laptop) and on both I've the reWASD software installed (each one with its corresponding license and with the purchased option of 'Advanced Mapping'). The same issue happens to me on both computers. The Joy-Con controller is original from Nintendo.
Thank you for your help!!