Hello! New to Rewasd still learning the ropes just had a quick question

[Six-Eared Macaque]

But it works with the main layer so thats good enough. Hopefully in time its fullly compatible. Thank you so much for the help.

[Six-Eared Macaque]

Ah! okey i got it working i put the keys that was not working for me on the main layer of the wooting keyboard. So the problem is the Fn toggle on the wooting keyboard that Rewasd doesn't seem to read correctly.

[1ncorrect]

reWASD has some peculiarities of interaction with the analog part of wooting, but there should be no problems with regular buttons.
Try to perform Clear data via → General.
After that, initialize the devices again and try to create a config from scratch.

[Six-Eared Macaque]

The keyboard and mouse are detected but... same issue. Maybe the wooting keyboard is not supported?

[1ncorrect]

Checked your config on my side — no issues. Maybe you have some special keyboard?
Make sure it is initialized correctly. Delete the group and enable Detection mode. Make sure you apply the configuration to the device that was blinking when you pressed the keyboard buttons.
Also, make sure the keyboard is initialized as a keyboard.

[Six-Eared Macaque]

I followed what you said and found the file, here you go.

[1ncorrect]

Hi.
It should work correctly.
In my case it is configured like this and works correctly.

Please send me your config, in which the mappings are set up correctly but do not work.
Your configs are stored here: C:\Users\Public\Documents\reWASD\Profiles
I need the correspondent *.rewasd file.

[Six-Eared Macaque]

I’m trying to set mouse movement to my keyboard keys, the keys am using are up-Ins(key) down-End(key) leftHome(key) right-Pgup(key). And when a apply it just doesn’t work. But if a change those keys with any of the alphabet keys it works flawlessly. So the keys i used the first time don’t work as key inputs?