Shift Cycle

[aspookybird]

I'm trying to get my Logitech F310 to cycle shift modes. Pushing the logitech button I have that set to from layer 0 to layer 1 to layer 2 to layer 0. Each time I push that button, it should cycle the layer from one to the next and back to the beginning each time I push it.

See screenshots below as it goes from Main Layer to Turbo AB to Turbo XY to Main Layer, each time I push that button. This seems like it should work, but it doesn't.
Layer 0 to 1
Layer 1 to 2
Layer 2 to 0

[Support Agent]

It works as intended on the latest version of reWASD (8.0.0). However, I used a PS button on a DS4 controller.

Are you sure the Logitech button works as it should in your setup (does reWASD properly react to it when remap is turned off)?

[aspookybird]

If I remap the logitech button to anything, it works as that button, but on its own doesn't seem to do anything.

I should also point out that if I use it to toggle layer 0 to 1 to 0, that works, but I can't get it to got 0 to 1 to 2 to 0.

[Support Agent]

We'll need the config file you are using to test it on our side. Right-click on its name in reWASD and select [Open file location] to find it.

[aspookybird]

Hi, I'm not sure which config file you're looking for. Under reWASD's directory there are only
Engine.runtimeconfig
reWASDCommandLine.runtimeconfig
reWASDUACHelper.runtimeconfig
reWASDUI.runtimeconfig

[Support Agent]

Right-click on the config name in reWASD window and select [Open file location] in the context menu. reWASD will open an Explorer window with the config file selected.

[aspookybird]

Here it is!

[Support Agent]

You are missing the Custom Shift jump mapping from the 2nd to the 3rd layer in this config.

[aspookybird]

Yeah, I had to remove it because it didn't work. I've put it back on and here's the config, which doesn't work (tested again).

[Gogeba]

I tested your config myself (using DualSence as a controller) and was able to switch shift layers correctly.
Could you please try to map layer swaps to another button and see if it will work?

[aspookybird]

I moved the config to the select button and same problem, doesn't work. doesn't do any shift. I've attached it just in case. This is a logitech F310

https://www.logitechg.com/en-ca/products/gamepads/f310-gamepad.html

[1ncorrect]

I moved the config to the select button and same problem, doesn't work. doesn't do any shift. I've attached it just in case. This is a logitech F310

https://www.logitechg.com/en-ca/products/gamepads/f310-gamepad.html

Try switching the controller to X-input mode. Does the layer switching issue persist?

If yes, please record a video capturing the full reWASD window and ensure notifications for Shift change are enabled in → Overlay.

[aspookybird]

It is running in X-Input mode. I dunno what the issue is. My xbox one elite 2 controller died so I switched to this back up. But I guess that it's not going to work, so I'll just deal with no access to the custom shift mode until I get a replacement xbox controller.

[1ncorrect]

Do you have the ability to record the requested video?